Honda CR-V: Cooling System
Honda CR-V (2006–2011) Service Manual / Engine Cooling / Cooling System
Component Location Index
-
COOLANT SEPARATOR
-
EXHAUST GAS RECIRCULATION (EGR) PASSAGE
-
THERMOSTAT
-
RADIATOR
-
ENGINE COOLANT TEMPERATURE (ECT) SENSOR 2
-
RADIATOR FAN ASSEMBLY
-
A/C CONDENSER FAN ASSEMBLY
-
WATER PUMP
-
WATER PASSAGE
- Radiator Cap Test
- Water Passage Replacement
- EGR Passage Removal and Installation
- Fan, Fan Motor, Shroud Removal and Installation
- Radiator Replacement
READ NEXT:
Radiator Cap Test
1. Remove the radiator cap (A), wet the seal with
engine coolant, then install it on the pressure tester
(B) (commercially available).
2. Apply a pressure of 93-123 kPa
(0.95-1.25 kgf/cm2, 14-18 psi)
Water Passage Replacement
1. Drain the engine coolant.
2. Remove the alternator.
3. Remove the condenser fan shroud assembly.
4. Remove the A/C compressor without disconnecting
the A/C hoses (see step 34).
5. Remove the in
EGR Passage Removal and Installation
Removal
1. Drain the engine coolant.
2. Remove the air cleaner housing.
3. Remove the harness holder (A) from the bracket,
then remove the harness holder bracket (B).
4. Remove the upper radiator h
SEE MORE:
Malfunction Indicator Lamp
If the indicator comes on
while driving, it means one
of the engine’s emissions control
systems may have a problem. Even
though you may feel no difference in
your vehicle’s performance, it can
reduce your fuel economy and cause
increased emissions. Continued
operation may cause
Charging System
Component Location Index
CHARGING SYSTEM INDICATOR
(In the gauge control module)
UNDER-HOOD FUSE/RELAY BOX
(Has built-in ELECTRICAL LOAD
DETECTOR [ELD] UNIT)
BATTERY
ALTERNATOR
DRIVE BELT
AUTO-TENSIONER
Symptom Troubleshooting
Index
Charging system indicator does not come
© 2016-2026 Copyright www.hcrv.net
