Honda CR-V: Conventional Brake Components

Honda CR-V (2006–2011) Service Manual / Brakes / Conventional Brake Components

Special Tools

Honda CR-V. Conventional Brake Components

Honda CR-V. Conventional Brake Components

  1. Brake Caliper Piston  Compresor

Component Location Index

Honda CR-V. Conventional Brake Components

READ NEXT:

 Brake System

Brake System Inspection and Test Inspect the brake system components listed. Repair or replace any parts that are leaking or damaged. Component Inspections Brake System Test Brake pedal sinks/fades

 Front Brake

Front Brake Pad Inspection and Replacement Special Tools Required Brake caliper piston compressor 07 AAE-SEPA 101 CAUTION Frequent inhalation of brake pad dust, regardless of material composition, cou

 Master Cylinder

Master Cylinder Replacement NOTICE Do not spill brake flu id on the vehicle; it may damage the paint; if brake fluid gets on the paint, wash it off immediately with water. Be careful not to dam

SEE MORE:

 Rear Differential Fluid Inspection and Replacement

1. With the vehicle on level ground, inspect the differential fluid with the ignition switch turned to LOCK (0). 2. Use solvent and a brush to wash off any oil and dirt from the differential fluid inspection oil filler plug. 3. Remove the oil filler plug (A) and the sealing washer (B), then check

 DTC P2227: BARD Sensor Range/Performance Problem

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information. If DTC P0101, P0108, P1128, and/or P1129 are stored at the same time as DTC P2221, troubleshoot those DTCs first, then recheck for DTC P2221. 1. Turn the ignit

© 2016-2026 Copyright www.hcrv.net