Honda CR-V manuals

Honda CR-V: Driveline/Axle

Honda CR-V (2006–2011) Service Manual / Transaxle / Driveline/Axle

Special Tools

Honda CR-V. Driveline/Axle

Honda CR-V. Driveline/Axle

  1. Oil Seal Driver
  2. Attachment, 52 x 55 mm
  3. Half Shaft Base
  4. Threaded Adapter, 24 x 1.5 mm
  5. Threaded Adapter, 26 x 1.5 mm
  6. Attachment, 35 mm I.D.
  7. Driver
  8. Inner Handle, 30 mm
  9. Oil Seal Driver

Component Location Index

Honda CR-V. Driveline/Axle

READ NEXT:

 Driveshaft Inspection

1. Check the inboard boot (A) and the outboard boot (B) on the driveshaft (C) for cracks, damage, leaking grease, and loose boot bands (D). If any damage is found, replace the boot and boot bands. 2.

 Front Driveshaft Disassembly

Special Tools Required Threaded adapter, 26 x 1.5 mm 07XAC-001030A Slide hammer, 5/8"-18 UNF, commercially available Inboard Joint Side 1. Remove the set ring (A) from the inboard joint. 2. Remov

 Boot Band Installation

Special Tools Required Boot band tool, KD-3191 or equivalent, commercially available Boot band pliers, Kent-Moore J-35910 or equivalent, commercially available Double Loop Type 1. Fit the boot ends on

SEE MORE:

 Important Maintenance Precautions

If you have the required service done but do not reset the display, or reset the display without doing the service, the system will not show the correct maintenance intervals. This can lead to seriousmechanical problems because you will no longer have an accurate record of when maint

 Crankshaft Installation

Special Tools Required Driver 077 49-00 10000 Oil seal driver attachment, 96 mm 07ZAD-PNAA.100 1. Check the connecting rod bearing clearance with plastigage. 2. Check the main bearing clearance with plastigage. 3. Install the bearing halves in the engine block and connecting rods. 4. Apply a

© 2016-2025 Copyright www.hcrv.net