Honda CR-V manuals

Honda CR-V: Driveline/Axle

Honda CR-V (2006–2011) Service Manual / Transaxle / Driveline/Axle

Special Tools

Honda CR-V. Driveline/Axle

Honda CR-V. Driveline/Axle

  1. Oil Seal Driver
  2. Attachment, 52 x 55 mm
  3. Half Shaft Base
  4. Threaded Adapter, 24 x 1.5 mm
  5. Threaded Adapter, 26 x 1.5 mm
  6. Attachment, 35 mm I.D.
  7. Driver
  8. Inner Handle, 30 mm
  9. Oil Seal Driver

Component Location Index

Honda CR-V. Driveline/Axle

READ NEXT:

 Driveshaft Inspection

1. Check the inboard boot (A) and the outboard boot (B) on the driveshaft (C) for cracks, damage, leaking grease, and loose boot bands (D). If any damage is found, replace the boot and boot bands. 2.

 Front Driveshaft Disassembly

Special Tools Required Threaded adapter, 26 x 1.5 mm 07XAC-001030A Slide hammer, 5/8"-18 UNF, commercially available Inboard Joint Side 1. Remove the set ring (A) from the inboard joint. 2. Remov

 Boot Band Installation

Special Tools Required Boot band tool, KD-3191 or equivalent, commercially available Boot band pliers, Kent-Moore J-35910 or equivalent, commercially available Double Loop Type 1. Fit the boot ends on

SEE MORE:

 Recommended Tire Pressures

]The following chart shows the recommended cold tire pressures for most normal and high-speed driving conditions. Tire Size Cold Tire Pressure for Normal Driving 225/65R17 102T Front/Rear: 30 psi (210 kPa , 2.1 kgf/cm2 ) The compact spare tire pressure is: 60 psi

 Front Driveshaft Reassembly

Exploded View NOTE: Refer to the Exploded View as needed during this procedure. Inboard Joint Side 1. Wrap the splines with vinyl tape (A) to prevent damaging to the inboard boot. 2. Install the inboard boot onto the drives haft, then remove the vinyl tape. Be careful not to damage the inboard boo

© 2016-2026 Copyright www.hcrv.net