Honda CR-V manuals

Honda CR-V: Driveline/Axle

Honda CR-V (2006–2011) Service Manual / Transaxle / Driveline/Axle

Special Tools

Honda CR-V. Driveline/Axle

Honda CR-V. Driveline/Axle

  1. Oil Seal Driver
  2. Attachment, 52 x 55 mm
  3. Half Shaft Base
  4. Threaded Adapter, 24 x 1.5 mm
  5. Threaded Adapter, 26 x 1.5 mm
  6. Attachment, 35 mm I.D.
  7. Driver
  8. Inner Handle, 30 mm
  9. Oil Seal Driver

Component Location Index

Honda CR-V. Driveline/Axle

READ NEXT:

 Driveshaft Inspection

1. Check the inboard boot (A) and the outboard boot (B) on the driveshaft (C) for cracks, damage, leaking grease, and loose boot bands (D). If any damage is found, replace the boot and boot bands. 2.

 Front Driveshaft Disassembly

Special Tools Required Threaded adapter, 26 x 1.5 mm 07XAC-001030A Slide hammer, 5/8"-18 UNF, commercially available Inboard Joint Side 1. Remove the set ring (A) from the inboard joint. 2. Remov

 Boot Band Installation

Special Tools Required Boot band tool, KD-3191 or equivalent, commercially available Boot band pliers, Kent-Moore J-35910 or equivalent, commercially available Double Loop Type 1. Fit the boot ends on

SEE MORE:

 Exterior Lights

Component Location Index DAYTIME RUNNING LIGHTS CIRCUIT HEADLIGHTS FRONT SIDE MARKER/PARKING/ TURN SIGNAL LIGHTS HIGH MOUNT BRAKE LIGHT LICENSE PLATE LIGHT TAILLIGHT and BRAKE LIGHT REAR TURN SIGNAL LIGHT BACK-UP LIGHT LIGHTS-ON INDICATOR HIGH BEAM INDICATOR DRL INDICATOR COMB

 Differential Mount Replacement

Exploded View Differential Installation 1. Install rear differential mount assembly A to the rear differential assembly (B). 2. Jack up the rear differential. 3. Install the new set rings (A) onto the driveshafts, then insert the drives hafts into the rear differential. 4. Lift the rear different

© 2016-2025 Copyright www.hcrv.net