Honda CR-V manuals

Honda CR-V: Driveline/Axle

Honda CR-V (2006–2011) Service Manual / Transaxle / Driveline/Axle

Special Tools

Honda CR-V. Driveline/Axle

Honda CR-V. Driveline/Axle

  1. Oil Seal Driver
  2. Attachment, 52 x 55 mm
  3. Half Shaft Base
  4. Threaded Adapter, 24 x 1.5 mm
  5. Threaded Adapter, 26 x 1.5 mm
  6. Attachment, 35 mm I.D.
  7. Driver
  8. Inner Handle, 30 mm
  9. Oil Seal Driver

Component Location Index

Honda CR-V. Driveline/Axle

READ NEXT:

 Driveshaft Inspection

1. Check the inboard boot (A) and the outboard boot (B) on the driveshaft (C) for cracks, damage, leaking grease, and loose boot bands (D). If any damage is found, replace the boot and boot bands. 2.

 Front Driveshaft Disassembly

Special Tools Required Threaded adapter, 26 x 1.5 mm 07XAC-001030A Slide hammer, 5/8"-18 UNF, commercially available Inboard Joint Side 1. Remove the set ring (A) from the inboard joint. 2. Remov

 Boot Band Installation

Special Tools Required Boot band tool, KD-3191 or equivalent, commercially available Boot band pliers, Kent-Moore J-35910 or equivalent, commercially available Double Loop Type 1. Fit the boot ends on

SEE MORE:

 Checking Loads

The best way to confirmthat all loads are within limits is to check them at a public scale. For public scales in your area, check your local phone book, or contact your trailer dealer or rental agency for assistance. If you cannot get to a public scale, you can estimate the total trai

 MICU Input Test

NOTE: Before testing, troubleshoot the B-CAN System Diagnosis Test Mode A. 1. Turn the ignition switch OFF. 2. Disconnect the under-dash fuse/relay box connectors E, F, G, K, R, and T. NOTE: All connector views are wire side of female terminals. UNDER-DASH FUSE/RELAY BOX CONNECTOR E (42P) UNDER-D

© 2016-2025 Copyright www.hcrv.net