Honda CR-V manuals

Honda CR-V: Driveline/Axle

Honda CR-V (2006–2011) Service Manual / Transaxle / Driveline/Axle

Special Tools

Honda CR-V. Driveline/Axle

Honda CR-V. Driveline/Axle

  1. Oil Seal Driver
  2. Attachment, 52 x 55 mm
  3. Half Shaft Base
  4. Threaded Adapter, 24 x 1.5 mm
  5. Threaded Adapter, 26 x 1.5 mm
  6. Attachment, 35 mm I.D.
  7. Driver
  8. Inner Handle, 30 mm
  9. Oil Seal Driver

Component Location Index

Honda CR-V. Driveline/Axle

READ NEXT:

 Driveshaft Inspection

1. Check the inboard boot (A) and the outboard boot (B) on the driveshaft (C) for cracks, damage, leaking grease, and loose boot bands (D). If any damage is found, replace the boot and boot bands. 2.

 Front Driveshaft Disassembly

Special Tools Required Threaded adapter, 26 x 1.5 mm 07XAC-001030A Slide hammer, 5/8"-18 UNF, commercially available Inboard Joint Side 1. Remove the set ring (A) from the inboard joint. 2. Remov

 Boot Band Installation

Special Tools Required Boot band tool, KD-3191 or equivalent, commercially available Boot band pliers, Kent-Moore J-35910 or equivalent, commercially available Double Loop Type 1. Fit the boot ends on

SEE MORE:

 MICU Input Test

NOTE: The MICU turns on the headlights (high beams) in a dim mode for the daytime running lights under the following conditions: The ignition switch is ON (II) The headlight switch is OFF The parking brake is released (parking brake switch OFF) If the vehicle is equipped with an opti

 VSA (Vehicle Stability Assist) System Components

Component Location Index VSA MODULATOR-CONTROL UNIT Removal and Installation UNDER-HOOD FUSE/RELAY BOX DATA LINK CONNECTOR (DLC) STEERING ANGLE SENSOR Replacement VSA OFF SWITCH Test RIGHT-REAR WHEEL SENSOR Replacement HUB BEARING UNIT (MAGNETIC ENCODER) Replace

© 2016-2025 Copyright www.hcrv.net