Honda CR-V: Conventional Brake Components

Honda CR-V (2006–2011) Service Manual / Brakes / Conventional Brake Components

Special Tools

Honda CR-V. Conventional Brake Components

Honda CR-V. Conventional Brake Components

  1. Brake Caliper Piston  Compresor

Component Location Index

Honda CR-V. Conventional Brake Components

READ NEXT:

 Brake System

Brake System Inspection and Test Inspect the brake system components listed. Repair or replace any parts that are leaking or damaged. Component Inspections Brake System Test Brake pedal sinks/fades

 Front Brake

Front Brake Pad Inspection and Replacement Special Tools Required Brake caliper piston compressor 07 AAE-SEPA 101 CAUTION Frequent inhalation of brake pad dust, regardless of material composition, cou

 Master Cylinder

Master Cylinder Replacement NOTICE Do not spill brake flu id on the vehicle; it may damage the paint; if brake fluid gets on the paint, wash it off immediately with water. Be careful not to dam

SEE MORE:

 DTC P0457: EVAP System Leak Detected/Fuel Fill Cap Loose or Missing

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information. 1. Check the fuel fill cap (the cap must say "Tighten to click"). It should turn 1/4 turn after it's tight, then it clicks. Is the correct fuel fill cap installed a

 System Description

SRS Components Airbags The SRS is a safety device which, when used with the seat belt, is designed to help protect the driver and front passenger in a frontal impact exceeding a certain set limit. The system consists of the SRS unit, including safing sensor and impact sensor (A), the cable reel (B

© 2016-2025 Copyright www.hcrv.net