Honda CR-V: Conventional Brake Components
Honda CR-V (2006–2011) Service Manual / Brakes / Conventional Brake Components
Special Tools
- Brake Caliper Piston Compresor
Component Location Index
- BRAKE SYSTEM INDICATOR
- Circuit Diagram
- Parking Brake Switch Test
- Brake Fluid Level Switch Test
- BRAKE HOSE and LINE
- Inspection
- Brake Hose Replacement
- PARKING DRUM BRAKE
- Inspection
- Shoe Replacement
- Shoe Lining Break-in
- REAR DISC BRAKE
- Pad Inspection and Replacement
- Disc Inspection
- Caliper Overhaul
- PARKING BRAKE
- Inspection and Adjustment
- Cable Replacement
- BRAKE PEDAL
- Brake Pedal and Brake Pedal Position Switch Adjustment
- Replacement
- FRONT BRAKE
- Pad Inspection and Replacement
- Disc Inspection
- Caliper Overhaul
- BRAKE BOOSTER
- Test
- Replacement
- MASTER CYLINDER
- Brake System Bleeding
- Replacement
- Inspection
READ NEXT:
Brake System
Brake System Inspection and Test
Inspect the brake system components listed. Repair or replace any parts that
are leaking or damaged.
Component Inspections
Brake System Test
Brake pedal sinks/fades
Front Brake
Front Brake Pad Inspection and Replacement
Special Tools Required
Brake caliper piston compressor 07 AAE-SEPA 101
CAUTION
Frequent inhalation of brake pad dust, regardless of
material composition, cou
Master Cylinder
Master Cylinder Replacement
NOTICE
Do not spill brake flu id on the vehicle; it may
damage the paint; if brake fluid gets on the paint,
wash it off immediately with water.
Be careful not to dam
SEE MORE:
Audio Unit Removal/Installation
Without navigation
SRS components are located in this area. Review the
SRS component location.
Also review the precautions and procedures in the SRS section before doing repairs or
service.
NOTE:
Put on gloves to protect your hands.
Take care not to scratch the dashboard and related
parts.
Lay
Lower Ball Joint Replacement
Special Tools Required
Ball joint remover, 32 mm 07MAC-SL0A 102
Ball joint thread protector, 14 mm 071AF-S3VA000
1. Remove the front wheel.
2. Remove the flange bolt and flange nuts from the
lower arm (A).
NOTE: During installation, install a new flange bolt
and new flange nuts. After lightly
© 2016-2026 Copyright www.hcrv.net
