Honda CR-V manuals

Honda CR-V: Driveline/Axle

Honda CR-V (2006–2011) Service Manual / Transaxle / Driveline/Axle

Special Tools

Honda CR-V. Driveline/Axle

Honda CR-V. Driveline/Axle

  1. Oil Seal Driver
  2. Attachment, 52 x 55 mm
  3. Half Shaft Base
  4. Threaded Adapter, 24 x 1.5 mm
  5. Threaded Adapter, 26 x 1.5 mm
  6. Attachment, 35 mm I.D.
  7. Driver
  8. Inner Handle, 30 mm
  9. Oil Seal Driver

Component Location Index

Honda CR-V. Driveline/Axle

READ NEXT:

 Driveshaft Inspection

1. Check the inboard boot (A) and the outboard boot (B) on the driveshaft (C) for cracks, damage, leaking grease, and loose boot bands (D). If any damage is found, replace the boot and boot bands. 2.

 Front Driveshaft Disassembly

Special Tools Required Threaded adapter, 26 x 1.5 mm 07XAC-001030A Slide hammer, 5/8"-18 UNF, commercially available Inboard Joint Side 1. Remove the set ring (A) from the inboard joint. 2. Remov

 Boot Band Installation

Special Tools Required Boot band tool, KD-3191 or equivalent, commercially available Boot band pliers, Kent-Moore J-35910 or equivalent, commercially available Double Loop Type 1. Fit the boot ends on

SEE MORE:

 Low Oil Pressure Indicator Circuit Troubleshooting (Open)

1. Connect the Honda Diagnostic System (HDS) to the data link connector (DLC) (see step 2). 2. Turn the ignition switch ON (II). 3. Make sure the HDS communicates with the vehicle and the powertrain control module (PCM). If it doesn't communicate, troubleshoot the DLC circuit. 4. Check for DTCs.

 To Select a Station

You can use any of five methods to find radio stations on the selected band: tune, seek, scan, the preset buttons, and auto select. TUNE - Use the TUNE bar to tune the radio to a desired frequency. Press the side of the bar to tune to a higher frequency, and press the side to tune t

© 2016-2026 Copyright www.hcrv.net