Honda CR-V: Conventional Brake Components
Honda CR-V (2006–2011) Service Manual / Brakes / Conventional Brake Components
Special Tools
- Brake Caliper Piston Compresor
Component Location Index
- BRAKE SYSTEM INDICATOR
- Circuit Diagram
- Parking Brake Switch Test
- Brake Fluid Level Switch Test
- BRAKE HOSE and LINE
- Inspection
- Brake Hose Replacement
- PARKING DRUM BRAKE
- Inspection
- Shoe Replacement
- Shoe Lining Break-in
- REAR DISC BRAKE
- Pad Inspection and Replacement
- Disc Inspection
- Caliper Overhaul
- PARKING BRAKE
- Inspection and Adjustment
- Cable Replacement
- BRAKE PEDAL
- Brake Pedal and Brake Pedal Position Switch Adjustment
- Replacement
- FRONT BRAKE
- Pad Inspection and Replacement
- Disc Inspection
- Caliper Overhaul
- BRAKE BOOSTER
- Test
- Replacement
- MASTER CYLINDER
- Brake System Bleeding
- Replacement
- Inspection
READ NEXT:
Brake System
Brake System Inspection and Test
Inspect the brake system components listed. Repair or replace any parts that
are leaking or damaged.
Component Inspections
Brake System Test
Brake pedal sinks/fades
Front Brake
Front Brake Pad Inspection and Replacement
Special Tools Required
Brake caliper piston compressor 07 AAE-SEPA 101
CAUTION
Frequent inhalation of brake pad dust, regardless of
material composition, cou
Master Cylinder
Master Cylinder Replacement
NOTICE
Do not spill brake flu id on the vehicle; it may
damage the paint; if brake fluid gets on the paint,
wash it off immediately with water.
Be careful not to dam
SEE MORE:
Removing a Disc
To remove a disc from the audio unit,
fold back the screen by pressing the
OPEN button. Press
the disc eject button (
) to
remove the disc. If you eject the disc,
but do not remove it from the slot,
the system will automatically reload
it after 10 seconds and put it in pause
mode.
VTC Actuator, Exhaust Camshaft Sprocket
Replacement
Removal
1. Remove the cam chain.
2. Hold the camshaft with an open-end wrench, then
loosen the variable valve timing control (VTC)
actuator mounting bolt and exhaust camshaft
sprocket mounting bolt.
3. If the VTC actuator will be reused, do these steps.
Remove the intake camshaft, and seal the
© 2016-2025 Copyright www.hcrv.net
