Honda CR-V manuals

Honda CR-V: Driveline/Axle

Honda CR-V (2006–2011) Service Manual / Transaxle / Driveline/Axle

Special Tools

Honda CR-V. Driveline/Axle

Honda CR-V. Driveline/Axle

  1. Oil Seal Driver
  2. Attachment, 52 x 55 mm
  3. Half Shaft Base
  4. Threaded Adapter, 24 x 1.5 mm
  5. Threaded Adapter, 26 x 1.5 mm
  6. Attachment, 35 mm I.D.
  7. Driver
  8. Inner Handle, 30 mm
  9. Oil Seal Driver

Component Location Index

Honda CR-V. Driveline/Axle

READ NEXT:

 Driveshaft Inspection

1. Check the inboard boot (A) and the outboard boot (B) on the driveshaft (C) for cracks, damage, leaking grease, and loose boot bands (D). If any damage is found, replace the boot and boot bands. 2.

 Front Driveshaft Disassembly

Special Tools Required Threaded adapter, 26 x 1.5 mm 07XAC-001030A Slide hammer, 5/8"-18 UNF, commercially available Inboard Joint Side 1. Remove the set ring (A) from the inboard joint. 2. Remov

 Boot Band Installation

Special Tools Required Boot band tool, KD-3191 or equivalent, commercially available Boot band pliers, Kent-Moore J-35910 or equivalent, commercially available Double Loop Type 1. Fit the boot ends on

SEE MORE:

 Actual Mileage and EPA Fuel Economy Estimates Comparison.

Fuel economy is not a fixed number. It varies based on driving conditions, driving habits and vehicle condition. Therefore, it is not possible for one set of estimates to predict fuel economy precisely for all drivers in all environments. The EPA fuel economy estimates shown in the exam

 Additional Safety Precautions

Do not attempt to deactivate your airbags. Together, airbags and seat belts provide the best protection. Do not tamper with airbag components or wiring for any reason. Tampering could cause the airbags to deploy, possibly causing very serious injury. Do not expose the front passenger

© 2016-2025 Copyright www.hcrv.net