Honda CR-V manuals

Honda CR-V: Driveline/Axle

Honda CR-V (2006–2011) Service Manual / Transaxle / Driveline/Axle

Special Tools

Honda CR-V. Driveline/Axle

Honda CR-V. Driveline/Axle

  1. Oil Seal Driver
  2. Attachment, 52 x 55 mm
  3. Half Shaft Base
  4. Threaded Adapter, 24 x 1.5 mm
  5. Threaded Adapter, 26 x 1.5 mm
  6. Attachment, 35 mm I.D.
  7. Driver
  8. Inner Handle, 30 mm
  9. Oil Seal Driver

Component Location Index

Honda CR-V. Driveline/Axle

READ NEXT:

 Driveshaft Inspection

1. Check the inboard boot (A) and the outboard boot (B) on the driveshaft (C) for cracks, damage, leaking grease, and loose boot bands (D). If any damage is found, replace the boot and boot bands. 2.

 Front Driveshaft Disassembly

Special Tools Required Threaded adapter, 26 x 1.5 mm 07XAC-001030A Slide hammer, 5/8"-18 UNF, commercially available Inboard Joint Side 1. Remove the set ring (A) from the inboard joint. 2. Remov

 Boot Band Installation

Special Tools Required Boot band tool, KD-3191 or equivalent, commercially available Boot band pliers, Kent-Moore J-35910 or equivalent, commercially available Double Loop Type 1. Fit the boot ends on

SEE MORE:

 Connectors and Harnesses

Connector Index Identification numbers have been assigned to in-line connectors, junction connectors, and terminals. The number is preceded by the letter ºC" for connectors "G" for ground terminals or "T" for non-ground terminals. * 1. With seat heater * 2: Without seat heater Connector to Harne

 Pressure Test

Special Tools Required A/T clutch pressure gauge set 07406-0020400 or 07406-0020401 A/T pressure hose, 2,210 mm 07MAJ-PY4011A A/T pressure hose adapter 07MAJ-PY40120 1. Make sure the transmission fluid is filled to the proper level. 2. 4WD model: Raise the vehicle on a lift, make sure it is s

© 2016-2025 Copyright www.hcrv.net