Honda CR-V: Conventional Brake Components

Honda CR-V (2006–2011) Service Manual / Brakes / Conventional Brake Components

Special Tools

Honda CR-V. Conventional Brake Components

Honda CR-V. Conventional Brake Components

  1. Brake Caliper Piston  Compresor

Component Location Index

Honda CR-V. Conventional Brake Components

READ NEXT:

 Brake System

Brake System Inspection and Test Inspect the brake system components listed. Repair or replace any parts that are leaking or damaged. Component Inspections Brake System Test Brake pedal sinks/fades

 Front Brake

Front Brake Pad Inspection and Replacement Special Tools Required Brake caliper piston compressor 07 AAE-SEPA 101 CAUTION Frequent inhalation of brake pad dust, regardless of material composition, cou

 Master Cylinder

Master Cylinder Replacement NOTICE Do not spill brake flu id on the vehicle; it may damage the paint; if brake fluid gets on the paint, wash it off immediately with water. Be careful not to dam

SEE MORE:

 Electronic Throttle Control System

Component Location Index ELECTRONIC THROTTLE CONTROL SYSTEM (ETCS) CONTROL RELAY (RELAY SOCKET F) POWERTRAIN CONTROL MODULE (PCM) General Troubleshooting Information Replacement THROTTLE ACTUATOR and THROTTLE POSITION (TP) SENSOR ACCELERATOR PEDAL MODULE

 Rear Seat

Rear Seat Armrest Removal/Installation NOTE: Take care not to tear the seams or damage the seat covers. 1. Remove the E-ring (A) from the right side portion on the armrest pivot. 2. Slide the armrest (A) toward the right side, then release the left pivot shaft (B) from the bushing (C). 3. Release

© 2016-2025 Copyright www.hcrv.net