Honda CR-V: Audio, Navigation, and Telematics
Honda CR-V (2006–2011) Service Manual / Audio, Navigation,
and Telematics
- Audio System
- System Description
- Self-diagnostic Function
- Symptom Troubleshooting
- Sound Quality Diagnosis
- Audio Unit Removal/Installation
- Navigation System
READ NEXT:
Audio System
Component Location Index
LEFT REAR DOOR SPEAKER
AUDIO REMOTE SWITCH (Except LX model)
LEFT TWEETER (Except LX model)
DRIVER'S DOOR SPEAKER
AUDIO UNIT
NAVIGATION UNIT
RIGHT TWEETER
(Except LX
System Description
Overview
The audio unit acts as the "processor" for all audio functions. Select audio
functions from the audio unit, the audio
remote (on the steering wheel), or by using the navigation voice control
Self-diagnostic Function
Without Navigation
The audio system has a self-diagnostic function. To run the self-diagnostic
function, do the following:
How to check for audio system condition
NOTE: The audio unit must be in the
SEE MORE:
Upper Arm Replacement
1. Raise the rear of the vehicle, and support it with safety stands in the
proper locations.
2. Remove the rear wheel.
3. Place a floor jack under the trailing arm, and
support the suspension.
4. Remove the wheel sensor harness bracket (A) from
the upper arm (B).
5. Remove the flange bolts (A),
F-CAN Circuit Troubleshooting
NOTE: Information marked with an asterisk (*) applies
to the CANL line.
1. Turn the ignition switch OFF.
2. Jump the SCS line with the HDS.
3. Disconnect PCM connector A (44P), then disconnect
the HDS.
4. Measure resistance between PCM connector
terminals A36 and A37.
Is there about 95- 116 Ω
© 2016-2025 Copyright www.hcrv.net
