Honda CR-V: Conventional Brake Components
Honda CR-V (2006–2011) Service Manual / Brakes / Conventional Brake Components
Special Tools
- Brake Caliper Piston Compresor
Component Location Index
- BRAKE SYSTEM INDICATOR
- Circuit Diagram
- Parking Brake Switch Test
- Brake Fluid Level Switch Test
- BRAKE HOSE and LINE
- Inspection
- Brake Hose Replacement
- PARKING DRUM BRAKE
- Inspection
- Shoe Replacement
- Shoe Lining Break-in
- REAR DISC BRAKE
- Pad Inspection and Replacement
- Disc Inspection
- Caliper Overhaul
- PARKING BRAKE
- Inspection and Adjustment
- Cable Replacement
- BRAKE PEDAL
- Brake Pedal and Brake Pedal Position Switch Adjustment
- Replacement
- FRONT BRAKE
- Pad Inspection and Replacement
- Disc Inspection
- Caliper Overhaul
- BRAKE BOOSTER
- Test
- Replacement
- MASTER CYLINDER
- Brake System Bleeding
- Replacement
- Inspection
READ NEXT:
Brake System
Brake System Inspection and Test
Inspect the brake system components listed. Repair or replace any parts that
are leaking or damaged.
Component Inspections
Brake System Test
Brake pedal sinks/fades
Front Brake
Front Brake Pad Inspection and Replacement
Special Tools Required
Brake caliper piston compressor 07 AAE-SEPA 101
CAUTION
Frequent inhalation of brake pad dust, regardless of
material composition, cou
Master Cylinder
Master Cylinder Replacement
NOTICE
Do not spill brake flu id on the vehicle; it may
damage the paint; if brake fluid gets on the paint,
wash it off immediately with water.
Be careful not to dam
SEE MORE:
Reminder Systems
Component Location Index
GAUGE CONTROL MODULE
MICU
Circuit Diagram
Control Unit Input Test
NOTE: Before testing, troubleshoot the B-CAN System Diagnosis Test Mode A.
MICU
1. Turn the ignition switch OFF.
2. Remove the left kick panel.
3. Disconnect the under-dash fuse/relay box connectors.
DTC P0731: Problem in 1st Clutch and 1st
Clutch Hydraulic Circuit
NOTE: Before you troubleshoot, record all freeze data and any on-board
snapshot, and review General Troubleshooting Information.
1. Warm up the engine to normal operating
temperature (the radiator fan comes on).
2. Make sure that the transmission is filled to the
proper level, and check for fluid
© 2016-2025 Copyright www.hcrv.net
