Honda CR-V: Conventional Brake Components

Honda CR-V (2006–2011) Service Manual / Brakes / Conventional Brake Components

Special Tools

Honda CR-V. Conventional Brake Components

Honda CR-V. Conventional Brake Components

  1. Brake Caliper Piston  Compresor

Component Location Index

Honda CR-V. Conventional Brake Components

READ NEXT:

 Brake System

Brake System Inspection and Test Inspect the brake system components listed. Repair or replace any parts that are leaking or damaged. Component Inspections Brake System Test Brake pedal sinks/fades

 Front Brake

Front Brake Pad Inspection and Replacement Special Tools Required Brake caliper piston compressor 07 AAE-SEPA 101 CAUTION Frequent inhalation of brake pad dust, regardless of material composition, cou

 Master Cylinder

Master Cylinder Replacement NOTICE Do not spill brake flu id on the vehicle; it may damage the paint; if brake fluid gets on the paint, wash it off immediately with water. Be careful not to dam

SEE MORE:

 Rear Door

Rear Door Panel Removal/Installation Special Tools Required KTC trim tool set SOJATP2014 * Trim pad remover, Snap-on A 177 A or equivalent, commercially available * Available through the American Honda Tool and Equipment Program; call 888-424-6857 NOTE: Use the appropriate tool from the KTC

 Replacing Tires andWheels

Replace your tires with radial tires of the same size, load range, speed rating, and maximum cold tire pressure rating (as shown on the tire’s sidewall). Mixing radial and bias-ply tires on your vehicle can reduce braking ability, traction, and steering accuracy. Using tires of a di

© 2016-2025 Copyright www.hcrv.net