Honda CR-V: Driveline/Axle
Honda CR-V (2006–2011) Service Manual / Transaxle / Driveline/Axle
Special Tools
- Oil Seal Driver
- Attachment, 52 x 55 mm
- Half Shaft Base
- Threaded Adapter, 24 x 1.5 mm
- Threaded Adapter, 26 x 1.5 mm
- Attachment, 35 mm I.D.
- Driver
- Inner Handle, 30 mm
- Oil Seal Driver
Component Location Index
- BOOT BAND
- Removal
- Installation
- INTERMEDIATE SHAFT
- Removal
- Disassembly
- Reassembly
- Installation
- FRONT DRIVES HAFT
- Inspection
- Removal
- Disassembly
- Reassembly
- Installation
- PROPELLER SHAFT
- Inspection
- Removal
- Installation
- REAR DRIVESHAFT
- Inspection
- Removal
- Disassembly
- Reassembly
- Installation
- Driveshaft Inspection
- Front Driveshaft Disassembly
- Boot Band Installation
- Front Driveshaft Reassembly
- Front Driveshaft Installation
- Intermediate Shaft
- Rear Driveshaft
- Propeller Shaft
READ NEXT:
Driveshaft Inspection
1. Check the inboard boot (A) and the outboard boot
(B) on the driveshaft (C) for cracks, damage, leaking
grease, and loose boot bands (D). If any damage is
found, replace the boot and boot bands.
2.
Front Driveshaft Disassembly
Special Tools Required
Threaded adapter, 26 x 1.5 mm 07XAC-001030A
Slide hammer, 5/8"-18 UNF, commercially available
Inboard Joint Side
1. Remove the set ring (A) from the inboard joint.
2. Remov
Boot Band Installation
Special Tools Required
Boot band tool, KD-3191 or equivalent, commercially
available
Boot band pliers, Kent-Moore J-35910 or equivalent,
commercially available
Double Loop Type
1. Fit the boot ends on
SEE MORE:
DTC P16CO: PCM A/T Control System
Incomplete Update
NOTE:
Before you troubleshoot, record all freeze data and any on-board
snapshot, and review General Troubleshooting Information.
This code is indicated when PCM updating is
incomplete.
1. Update the A/T software in the PCM.
2. Check whether the DTC P16CO is indicated in the
DTCs/Freeze Data
Oil Pan Removal
1. If the engine is already out of the vehicle, go to step
20.
2. Raise the vehicle on the lift to full height.
3. Drain the engine oil.
4. Remove the front wheels.
5. Remove the splash shield (see step 21).
6. Disconnect the air fuel ratio (A/F) sensor connector
and secondary heated oxygen sen
© 2016-2025 Copyright www.hcrv.net
