Honda CR-V: Driveline/Axle
Honda CR-V (2006–2011) Service Manual / Transaxle / Driveline/Axle
Special Tools
- Oil Seal Driver
- Attachment, 52 x 55 mm
- Half Shaft Base
- Threaded Adapter, 24 x 1.5 mm
- Threaded Adapter, 26 x 1.5 mm
- Attachment, 35 mm I.D.
- Driver
- Inner Handle, 30 mm
- Oil Seal Driver
Component Location Index
- BOOT BAND
- Removal
- Installation
- INTERMEDIATE SHAFT
- Removal
- Disassembly
- Reassembly
- Installation
- FRONT DRIVES HAFT
- Inspection
- Removal
- Disassembly
- Reassembly
- Installation
- PROPELLER SHAFT
- Inspection
- Removal
- Installation
- REAR DRIVESHAFT
- Inspection
- Removal
- Disassembly
- Reassembly
- Installation
- Driveshaft Inspection
- Front Driveshaft Disassembly
- Boot Band Installation
- Front Driveshaft Reassembly
- Front Driveshaft Installation
- Intermediate Shaft
- Rear Driveshaft
- Propeller Shaft
READ NEXT:
Driveshaft Inspection
1. Check the inboard boot (A) and the outboard boot
(B) on the driveshaft (C) for cracks, damage, leaking
grease, and loose boot bands (D). If any damage is
found, replace the boot and boot bands.
2.
Front Driveshaft Disassembly
Special Tools Required
Threaded adapter, 26 x 1.5 mm 07XAC-001030A
Slide hammer, 5/8"-18 UNF, commercially available
Inboard Joint Side
1. Remove the set ring (A) from the inboard joint.
2. Remov
Boot Band Installation
Special Tools Required
Boot band tool, KD-3191 or equivalent, commercially
available
Boot band pliers, Kent-Moore J-35910 or equivalent,
commercially available
Double Loop Type
1. Fit the boot ends on
SEE MORE:
DTC P1658: ETCS Control Relay ON
Malfunction
NOTE: Before you troubleshoot. record all freeze data and any on-board
snapshot, and review the general troubleshooting information.
1. Turn the ignition switch ON (II).
2. Do the ETCS TEST in the INSPECTION MENU with
the HDS.
Is the RELAY circuit OK? YES-Intermittent failure, the system is OK a
DTC P0752: Shift Solenoid Valve A Stuck ON
NOTE: Before you troubleshoot, record all freeze data and any on-board
snapshot, and review General Troubleshooting Information.
1. Warm up the engine to normal operating
temperature (the radiator fan comes on).
2. Make sure that the transmission is filled to the
proper level, and check for fluid
© 2016-2025 Copyright www.hcrv.net
