Honda CR-V: Conventional Brake Components
Special Tools


- Brake Caliper Piston Compresor
Component Location Index

- BRAKE SYSTEM INDICATOR
- Circuit Diagram
- Parking Brake Switch Test
- Brake Fluid Level Switch Test
- BRAKE HOSE and LINE
- Inspection
- Brake Hose Replacement
- PARKING DRUM BRAKE
- Inspection
- Shoe Replacement
- Shoe Lining Break-in
- REAR DISC BRAKE
- Pad Inspection and
Replacement
- Disc Inspection
- Caliper Overhaul
- PARKING BRAKE
- Inspection and Adjustment
- Cable Replacement
- BRAKE PEDAL
- Brake Pedal and Brake Pedal Position Switch Adjustment
- Replacement
- FRONT BRAKE
- Pad Inspection and
Replacement
- Disc Inspection
- Caliper Overhaul
- BRAKE BOOSTER
- MASTER CYLINDER
- Brake System Bleeding
- Replacement
- Inspection
READ NEXT:
Brake System Inspection and Test
Inspect the brake system components listed. Repair or replace any parts that
are leaking or damaged.
Component Inspections
Brake System Test
Brake pedal sinks/fades
Front Brake Pad Inspection and Replacement
Special Tools Required
Brake caliper piston compressor 07 AAE-SEPA 101
CAUTION
Frequent inhalation of brake pad dust, regardless of
material composition, cou
Master Cylinder Replacement
NOTICE
Do not spill brake flu id on the vehicle; it may
damage the paint; if brake fluid gets on the paint,
wash it off immediately with water.
Be careful not to dam
SEE MORE:
When preparing to tow, and before
driving away, be sure to check the
following:
The vehicle has been properly
serviced, and the suspension and
the cooling system are in good
operating condition.
The trailer has been properly
serviced and is in good condition.
All weights and loads are
Testing of Readiness Codes
If you take your vehicle for an
emissions test shortly after the
battery has been disconnected or
gone dead, it may not pass the test.
This is because of certain ‘‘readiness
codes’’ that must be set in the onboard
diagnostics for the emissions
systems
© 2016-2025 Copyright www.hcrv.net
