Honda CR-V manuals

Honda CR-V: Engine Block

Honda CR-V (2006–2011) Service Manual / Engine Mechanical / Engine Block

Special Tools

Honda CR-V. Engine Block

Honda CR-V. Engine Block

  1. Oil Seal Driver Attachment, 96 mm

  2. Driver

Component Location Index

Honda CR-V. Engine Block

Honda CR-V. Engine Block

READ NEXT:

 Connecting Rod and Crankshaft End Play Inspection

1. Remove the oil pump. 2. Remove the baffle plates (see step 7). 3. Measure the connecting rod end play with a feeler gauge between the connecting rod and crankshaft. Connecting Rod End Play Standa

 Connecting Rod Bearing Replacement

Rod Bearing Clearance Inspection 1. Remove the oil pump. 2. Remove the baffle plates (see step 7). 3. Remove the connecting rod cap and bearing half. 4. Clean the crankshaft rod journal and bearing

 Oil Pan Removal

1. If the engine is already out of the vehicle, go to step 20. 2. Raise the vehicle on the lift to full height. 3. Drain the engine oil. 4. Remove the front wheels. 5. Remove the splash shield (se

SEE MORE:

 General Troubleshooting Information

DTC (Diagnostic Trouble Codes) The self-diagnostic function of the SRS system allows it to locate the causes of system problems and then store this information in memory. For easier troubleshooting, this data can be retrieved via a data link circuit. When you turn the ignition switch ON (II), the

 Glass

Component Location Index WINDSHIELD MOLDING MOLDING UPPER SEAL UPPER RUBBER DAM CLIP, 2 WINDSHIELD SIDE TRIM SIDE RUBBER DAM WINDSHIELD RETAINER,8 QUARTER GLASS MOLDING CLIP, 1 CLIP, 2 QUARTER GLASS ULEV STICKER FRONT SEAL UPPER RUBBER DAM UPPER FASTENER 2 FASTENER 2 LOW

© 2016-2025 Copyright www.hcrv.net