Honda CR-V manuals

Honda CR-V: Engine Cooling

Honda CR-V (2006–2011) Service Manual / Engine Cooling

READ NEXT:

 Cooling System

Component Location Index COOLANT SEPARATOR EXHAUST GAS RECIRCULATION (EGR) PASSAGE THERMOSTAT RADIATOR ENGINE COOLANT TEMPERATURE (ECT) SENSOR 2 RADIATOR FAN ASSEMBLY A/C COND

 Radiator Cap Test

1. Remove the radiator cap (A), wet the seal with engine coolant, then install it on the pressure tester (B) (commercially available). 2. Apply a pressure of 93-123 kPa (0.95-1.25 kgf/cm2, 14-18 psi)

 Water Passage Replacement

1. Drain the engine coolant. 2. Remove the alternator. 3. Remove the condenser fan shroud assembly. 4. Remove the A/C compressor without disconnecting the A/C hoses (see step 34). 5. Remove the in

SEE MORE:

 Fan, Fan Motor, Shroud Removal and Installation

Removal 1. Remove the hood support rod, then use it as shown to prop the hood in the wide-open position. 2. Remove the bulkhead cover. 3. Disconnect the fan motor connectors (A) and hood switch connector (B), then remove the harness clips (C). 4. Remove the radiator upper brackets (A), then remov

 Warranty Coverages

U.S. Owners Your new vehicle is covered by these warranties: New Vehicle Limited Warranty - covers your new vehicle, except for the battery, emissions control systems, and accessories against defects in materials and workmanship. Emissions Control Systems Defects Warranty and Emission

© 2016-2025 Copyright www.hcrv.net