Honda CR-V: Steering
Honda CR-V (2006–2011) Service Manual / Steering
Special Tools
- Piston Seal Ring Sizing Tool
- Bushing Base
- Piston Seal Ring Guide
- Cylinder End Seal Slide
- Locknut Wrench, 40 mm
- Ball Joint Remover, 28 mm
- Valve Seal Ring Sizing Tool
- Sleeve Seal Ring Guide
- Pulley Holder
- Sleeve Seal Ring Sizing Tool, 36 mm
- P/S Joint Adapter (pump)
- P/S Joint Adapter (Hose)
- Cylinder End Seal Remover Attachment
- P/S Pressure Gauge
- Driver
- Attachment, 28 x 30 mm
Component Location Index
- POWER STEERING FLUID RESERVOIR
- Fluid Leakage Inspection
- Fluid Replacement
- Power Steering Hose, Line, and Pressure Switch Replacement
- POWER STEERING PUMP
- Drive Belt Inspection
- Pressure Test with T/N 07406-0010001
- Pressure Test with T/N 07406-001000A or 07406-001A101
- Replacement
- Overhaul
- DRIVER'S AIRBAG
- Replacement
- STEERING WHEEL
- Removal
- Disassembly/Reassembly
- Installation
- STEERING COLUMN
- Removal and Installation
- Steering Column/Tilt/Telescopic/Lock Lever Inspection
- Steering Lock Replacement
- POWER STEERING GEARBOX
- Rack Guide Adjustment
- Removal
- Overhaul
- Installation
- Tie-rod Ball Joint Boot Replacement
- Gearbox Mount Cushion Replacement
Symptom Troubleshooting Index
Find the symptom in the chart below, and do the related procedures in the order listed until you find the cause.
READ NEXT:
Symptom Troubleshooting
Hard Steering
1. Check the power assist.
Is the initial turning load more than 34 N (3.5 kgf,
7.7 Ibf) ?
YES-Go to step 2.
NO-Power assist is OK.
2. Connect the P/S joint adapter (pump), P/S joint
Pump Pressure Test
Pump Pressure Test with T/N 07406-0010001
Special Tools Required
P/S joint adapter (pump) 07ZAK-S7C0100
P/S joint adapter (hose) 07ZAK-S7C0200
P/S pressure gauge 07406-0010001
Check the fluid pre
Pump
Pump Replacement
1. Place a suitable container under the vehicle.
2. Drain the power steering fluid from the reservoir.
3. Remove the drive belt (A) from the pump pulley.
4. Cover the auto-tensione
SEE MORE:
Modifying Your Vehicle
Removing parts from your vehicle,
or replacing components, with
non-Honda components could
seriously affect your vehicle’s
handling, stability, and reliability.
Here are some examples:
Lowering the vehicle with a non-
Honda suspension kit that
significantly reduces ground
clearance
Loading Discs in the In-dash Disc Changer
Your vehicle’s in-dash disc changer
holds up to six discs.
1. Press the LOAD button until you
hear a beep and see ‘‘LOAD’’ on
the display.
To load only one CD, press and
release the LOAD button.
2. The disc number for an empty
position is highlighted and the red
disc load in
© 2016-2025 Copyright www.hcrv.net
