Honda CR-V manuals

Honda CR-V: Engine Block

Honda CR-V (2006–2011) Service Manual / Engine Mechanical / Engine Block

Special Tools

Honda CR-V. Engine Block

Honda CR-V. Engine Block

  1. Oil Seal Driver Attachment, 96 mm

  2. Driver

Component Location Index

Honda CR-V. Engine Block

Honda CR-V. Engine Block

READ NEXT:

 Connecting Rod and Crankshaft End Play Inspection

1. Remove the oil pump. 2. Remove the baffle plates (see step 7). 3. Measure the connecting rod end play with a feeler gauge between the connecting rod and crankshaft. Connecting Rod End Play Standa

 Connecting Rod Bearing Replacement

Rod Bearing Clearance Inspection 1. Remove the oil pump. 2. Remove the baffle plates (see step 7). 3. Remove the connecting rod cap and bearing half. 4. Clean the crankshaft rod journal and bearing

 Oil Pan Removal

1. If the engine is already out of the vehicle, go to step 20. 2. Raise the vehicle on the lift to full height. 3. Drain the engine oil. 4. Remove the front wheels. 5. Remove the splash shield (se

SEE MORE:

 Sound Quality Diagnosis

Special Tools Required Diagnostics CD 07AAZ-SDBA100 Use the following tests to check sound quality. NOTE: Before beginning the following tests, write down the customer's bass, treble, fader and balance settings, and then set them to their center positions for testing. Left/Right Channel 10 Do this

 Break-in Period

Help assure your vehicle’s future reliability and performance by paying extra attention to how you drive during the first 600 miles (1,000 km). During this period: Avoid full-throttle starts and rapid acceleration. Do not change the oil until the scheduled maintenance time. Avoid har

© 2016-2025 Copyright www.hcrv.net