Honda CR-V: Steering

Special Tools

Honda CR-V. Steering

Honda CR-V. Steering

  1. Piston Seal Ring Sizing Tool
  2. Bushing Base
  3. Piston Seal Ring Guide
  4. Cylinder End Seal Slide
  5. Locknut Wrench, 40 mm
  6. Ball Joint Remover, 28 mm
  7. Valve Seal Ring Sizing Tool
  8. Sleeve Seal Ring Guide
  9. Pulley Holder
  10. Sleeve Seal Ring Sizing Tool, 36 mm
  11. P/S Joint Adapter (pump)
  12. P/S Joint Adapter (Hose)
  13. Cylinder End Seal Remover Attachment
  14. P/S Pressure Gauge
  15. Driver
  16. Attachment, 28 x 30 mm

Component Location Index

Honda CR-V. Steering

Symptom Troubleshooting Index

Find the symptom in the chart below, and do the related procedures in the order listed until you find the cause.

Honda CR-V. Steering

Honda CR-V. Steering

READ NEXT:

 Symptom Troubleshooting

Hard Steering 1. Check the power assist. Is the initial turning load more than 34 N (3.5 kgf, 7.7 Ibf) ? YES-Go to step 2. NO-Power assist is OK. 2. Connect the P/S joint adapter (pump), P/S joint

 Pump Pressure Test

Pump Pressure Test with T/N 07406-0010001 Special Tools Required P/S joint adapter (pump) 07ZAK-S7C0100 P/S joint adapter (hose) 07ZAK-S7C0200 P/S pressure gauge 07406-0010001 Check the fluid pre

 Pump

Pump Replacement 1. Place a suitable container under the vehicle. 2. Drain the power steering fluid from the reservoir. 3. Remove the drive belt (A) from the pump pulley. 4. Cover the auto-tensione

SEE MORE:

 Protecting Small Children

Child Seat Type Many states, Canadian provinces and territories allow a child one year of age or older who also meets the minimum size and weight requirements to transition from a rear-facing child seat to a forward facing seat. Know the requirements where you are driving and foll

 Center Upper Dashboard Panel Removal/Installation

Special Tools Required KTC trim tool set SOJATP2014 * * Available through the American Honda Tool and Equipment Program; call 888-424-6857 NOTE: Put on gloves to protect your hands. Use the appropriate tool from the KTC trim tool set to avoid damage when prying components. Take care not to scra

© 2016-2025 Copyright www.hcrv.net