Honda CR-V manuals

Honda CR-V: Engine Block

Honda CR-V (2006–2011) Service Manual / Engine Mechanical / Engine Block

Special Tools

Honda CR-V. Engine Block

Honda CR-V. Engine Block

  1. Oil Seal Driver Attachment, 96 mm

  2. Driver

Component Location Index

Honda CR-V. Engine Block

Honda CR-V. Engine Block

READ NEXT:

 Connecting Rod and Crankshaft End Play Inspection

1. Remove the oil pump. 2. Remove the baffle plates (see step 7). 3. Measure the connecting rod end play with a feeler gauge between the connecting rod and crankshaft. Connecting Rod End Play Standa

 Connecting Rod Bearing Replacement

Rod Bearing Clearance Inspection 1. Remove the oil pump. 2. Remove the baffle plates (see step 7). 3. Remove the connecting rod cap and bearing half. 4. Clean the crankshaft rod journal and bearing

 Oil Pan Removal

1. If the engine is already out of the vehicle, go to step 20. 2. Raise the vehicle on the lift to full height. 3. Drain the engine oil. 4. Remove the front wheels. 5. Remove the splash shield (se

SEE MORE:

 Steering Wheel

Steering Wheel Removal SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service. 1. Make sure you have the anti-theft code for the audio and the navigation system (if equipped), then write down the XM audio preset

 Electronic Throttle Control System

Component Location Index ELECTRONIC THROTTLE CONTROL SYSTEM (ETCS) CONTROL RELAY (RELAY SOCKET F) POWERTRAIN CONTROL MODULE (PCM) General Troubleshooting Information Replacement THROTTLE ACTUATOR and THROTTLE POSITION (TP) SENSOR ACCELERATOR PEDAL MODULE

© 2016-2025 Copyright www.hcrv.net