Honda CR-V: Engine Block
Honda CR-V (2006–2011) Service Manual / Engine Mechanical / Engine Block
Special Tools
-
Oil Seal Driver Attachment, 96 mm
-
Driver
Component Location Index
-
BAFFLE PLATE
-
LOVER BLOCK
-
DOWEL PINS
-
CRANKSHAFT OIL SEAL, TRANSMISSION END
-
THRUST WASHERS
-
ENGINE BLOCK
-
CRANKSHAFT
-
MAIN BEARINGS
-
PISTON RINGS
-
PISTON PIN
-
PISTON
-
CONNECTING ROD
-
ENGINE BLOCK
-
CONNECTING ROD BEARINGS
-
CONNECTING ROD BEARING CAP
-
CONNECTING ROD BOLTS
- Connecting Rod and Crankshaft End Play Inspection
- Connecting Rod Bearing Replacement
- Oil Pan Removal
- Crankshaft and Piston Removal
- Block and Piston Inspection
- Piston, Pin, and Connecting Rod Replacement
- Piston Ring Replacement
- Crankshaft Installation
- Oil Pan Installation
READ NEXT:
Connecting Rod and Crankshaft End Play
Inspection
1. Remove the oil pump.
2. Remove the baffle plates (see step 7).
3. Measure the connecting rod end play with a feeler
gauge between the connecting rod and crankshaft.
Connecting Rod End Play
Standa
Connecting Rod Bearing Replacement
Rod Bearing Clearance Inspection
1. Remove the oil pump.
2. Remove the baffle plates (see step 7).
3. Remove the connecting rod cap and bearing half.
4. Clean the crankshaft rod journal and bearing
Oil Pan Removal
1. If the engine is already out of the vehicle, go to step
20.
2. Raise the vehicle on the lift to full height.
3. Drain the engine oil.
4. Remove the front wheels.
5. Remove the splash shield (se
SEE MORE:
A/T Clutch Pressure Control Solenoid Valve
A/T Clutch Pressure Control Solenoid Valve A Test
1. Connect the HDS to the DLC (A).
2. Choose Clutch Pressure Control (Linear) Solenoid A
in the Miscellaneous Test Menu on the HDS.
NOTE: If the HDS does not communicate with, the
PCM, troubleshoot the DLC circuit.
3. Test A/T clutch pressure contr
To Change or Select Files
Use the SKIP button while a USB
flash memory device is playing to
change files.
SKIP - Each time you press the
(SKIP +) button, the system
skips forward to the beginning of the
next file. Press the (SKIP -)
button, to skip backward to the
beginning of the current file. Press it
ag
© 2016-2025 Copyright www.hcrv.net
