Honda CR-V: DTC Troubleshooting
Honda CR-V (2006–2011) Service Manual / Brakes / VSA (Vehicle Stability Assist) System Components / DTC Troubleshooting
- DTC 11, 13, 15, 17: Wheel Sensor (Open/Short to Body Ground/Short to Power)
- DTC 12, 14, 16, 18: Wheel Sensor (Electrical Noise/Intermittent Interruption)
- DTC 51: Motor Locked
- DTC 86: F-CAN Communication
- DTC 91: VSA System
READ NEXT:
DTC 11, 13, 15, 17: Wheel Sensor (Open/Short
to Body Ground/Short to Power)
1. Turn the ignition switch ON (II).
2. Check for DTCs with the HDS.
Is DTC 87 indicated with DTC 11,13,15, and/or 17
at the same time?
YES-Go to step 9.
NO-Go to step 3.
3. Clear the DTC with the
DTC 12, 14, 16, 18: Wheel Sensor (Electrical
Noise/Intermittent Interruption)
NOTE:
If the ABS and other indicators come on because of
electrical noise, the indicators will go off when you
test-drive the vehicle at 10 mph (15 km/h) or more
and noise is gone.
An incorrectl
DTC 51: Motor Locked
1. Turn the ignition switch ON (II).
2. Clear the DTC with the HDS.
3. Test-drive the vehicle. Drive the vehicle at 10 mph
(15 km/h) or more, with the engine speed at
2,500 rpm or more.
4. Check fo
SEE MORE:
A/C Signal Circuit Troubleshooting
NOTE:
Use this troubleshooting procedure if the A/C
compressor, the A/C condenser fan, and radiator fan are inoperative.
Before doing symptom troubleshooting, check for and resolve any
powertrain DTCs.
1. Turn the ignition switch ON (II).
2. Check if the blower motor operates at all speeds.
Pump Pressure Test
Pump Pressure Test with T/N 07406-0010001
Special Tools Required
P/S joint adapter (pump) 07ZAK-S7C0100
P/S joint adapter (hose) 07ZAK-S7C0200
P/S pressure gauge 07406-0010001
Check the fluid pressure as follows to determine
whether the trouble is in the pump or steering gearbox.
1. Check the
© 2016-2026 Copyright www.hcrv.net
