Honda CR-V: Technical Information
Honda CR-V (2006–2011) Owner's Manual / Technical Information
The diagrams in this section give you the dimensions and capacities of your vehicle and the locations of the identification numbers. It also includes information you should know about your vehicle’s tires and emissions control systems.
- Identification Numbers
- Specifications
- DOT Tire Quality Grading (U.S. Vehicles)
- Tire Labeling
- Tire Pressure Monitoring System (TPMS) - Required Federal Explanation
- Emissions Controls
- The Clean Air Act
- Crankcase Emissions Control System
- Evaporative Emissions Control System
- Onboard Refueling Vapor Recovery
- Exhaust Emissions Controls
- Replacement Parts
- ThreeWay Catalytic Converter
- Emissions Testing
READ NEXT:
Identification Numbers
Your vehicle has several identifying
numbers located in various places.
The vehicle identification number
(VIN) is the 17-digit number your
dealer uses to register your vehicle
for warranty
Specifications
Dimensions
Weights
Engine
Capacities
Capacities
*1: Excluding the oil remaining in the engine
*2: Including the coolant in the reserve tank and that remaining in the
engine
Reserve
DOT Tire Quality Grading (U.S. Vehicles)
The tires on your vehicle meet all
U.S. Federal Safety Requirements.
All tires are also graded for
treadwear, traction, and temperature
performance according to
Department of Transportation
SEE MORE:
Radiator Cap Test
1. Remove the radiator cap (A), wet the seal with
engine coolant, then install it on the pressure tester
(B) (commercially available).
2. Apply a pressure of 93-123 kPa
(0.95-1.25 kgf/cm2, 14-18 psi).
3. Check for a drop in pressure.
4. If the pressure drops, replace the cap.
Radiator Test
1. W
Glass
Component Location Index
WINDSHIELD MOLDING
MOLDING UPPER SEAL
UPPER RUBBER DAM
CLIP, 2
WINDSHIELD SIDE TRIM
SIDE RUBBER DAM
WINDSHIELD
RETAINER,8
QUARTER GLASS MOLDING
CLIP, 1
CLIP, 2
QUARTER GLASS
ULEV STICKER
FRONT SEAL
UPPER RUBBER DAM
UPPER FASTENER 2
FASTENER 2
LOW
© 2016-2025 Copyright www.hcrv.net
