Honda CR-V manuals

Honda CR-V: Engine Block

Honda CR-V (2006–2011) Service Manual / Engine Mechanical / Engine Block

Special Tools

Honda CR-V. Engine Block

Honda CR-V. Engine Block

  1. Oil Seal Driver Attachment, 96 mm

  2. Driver

Component Location Index

Honda CR-V. Engine Block

Honda CR-V. Engine Block

READ NEXT:

 Connecting Rod and Crankshaft End Play Inspection

1. Remove the oil pump. 2. Remove the baffle plates (see step 7). 3. Measure the connecting rod end play with a feeler gauge between the connecting rod and crankshaft. Connecting Rod End Play Standa

 Connecting Rod Bearing Replacement

Rod Bearing Clearance Inspection 1. Remove the oil pump. 2. Remove the baffle plates (see step 7). 3. Remove the connecting rod cap and bearing half. 4. Clean the crankshaft rod journal and bearing

 Oil Pan Removal

1. If the engine is already out of the vehicle, go to step 20. 2. Raise the vehicle on the lift to full height. 3. Drain the engine oil. 4. Remove the front wheels. 5. Remove the splash shield (se

SEE MORE:

 Connecting a USB Flash Memory Device

1. Open the upper glove box. 2. Push the release button to release the USB adapter cable. 3. Connect the USB flash memory device to the USB connector correctly and securely. When the USB flash memory device is connected, the USB indicator is shown in the display.

 Multiplex Integrated Control System

Component Location Index GAUGE CONTROL MODULE Input Test Replacement IMMOBILIZER-KEYLESS CONTROL UNIT (Built in receiver) MICU (Built into the under-dash fuse/relay box) Input Test Replacement General Troubleshooting Information Troubleshooting CAN Circuit Related Problems NOT

© 2016-2025 Copyright www.hcrv.net