Honda CR-V manuals

Honda CR-V: Engine Block

Honda CR-V (2006–2011) Service Manual / Engine Mechanical / Engine Block

Special Tools

Honda CR-V. Engine Block

Honda CR-V. Engine Block

  1. Oil Seal Driver Attachment, 96 mm

  2. Driver

Component Location Index

Honda CR-V. Engine Block

Honda CR-V. Engine Block

READ NEXT:

 Connecting Rod and Crankshaft End Play Inspection

1. Remove the oil pump. 2. Remove the baffle plates (see step 7). 3. Measure the connecting rod end play with a feeler gauge between the connecting rod and crankshaft. Connecting Rod End Play Standa

 Connecting Rod Bearing Replacement

Rod Bearing Clearance Inspection 1. Remove the oil pump. 2. Remove the baffle plates (see step 7). 3. Remove the connecting rod cap and bearing half. 4. Clean the crankshaft rod journal and bearing

 Oil Pan Removal

1. If the engine is already out of the vehicle, go to step 20. 2. Raise the vehicle on the lift to full height. 3. Drain the engine oil. 4. Remove the front wheels. 5. Remove the splash shield (se

SEE MORE:

 General Troubleshooting Information

Intermittent Failures The term "intermittent failure" means a system may have had a failure, but it checks OK now. If the malfunction indicator lamp (MIL) on the dash does not come on, check for poor connections or loose pins at all connectors related to the circuit that you are troubleshooting. If

 Vents, Heating, and A/C

Vents, Heating, and A/C Fan Control Dial Turn this dial to increase or decrease the fan speed and airflow. Temperature Control Dial Turning this dial clockwise increases the temperature of the airflow. Air Conditioning (A/C) Button This button turns the air conditioning on and off. T

© 2016-2025 Copyright www.hcrv.net