Honda CR-V: Engine Block

Special Tools

Honda CR-V. Engine Block

Honda CR-V. Engine Block

  1. Oil Seal Driver Attachment, 96 mm

  2. Driver

Component Location Index

Honda CR-V. Engine Block

Honda CR-V. Engine Block

READ NEXT:

 Connecting Rod and Crankshaft End Play Inspection

1. Remove the oil pump. 2. Remove the baffle plates (see step 7). 3. Measure the connecting rod end play with a feeler gauge between the connecting rod and crankshaft. Connecting Rod End Play Standa

 Connecting Rod Bearing Replacement

Rod Bearing Clearance Inspection 1. Remove the oil pump. 2. Remove the baffle plates (see step 7). 3. Remove the connecting rod cap and bearing half. 4. Clean the crankshaft rod journal and bearing

 Oil Pan Removal

1. If the engine is already out of the vehicle, go to step 20. 2. Raise the vehicle on the lift to full height. 3. Drain the engine oil. 4. Remove the front wheels. 5. Remove the splash shield (se

SEE MORE:

 Idle Control System

Component Location Index POWER STEERING PRESSURE (PSP) SWITCH Signal Circuit Troubleshooting A/C COMPRESSOR CLUTCH RELAY (RELAY SOCKET A) Signal Circuit Troubleshooting POWERTRAIN CONTROL MODULE (PCM) General Troubleshooting Information Replacement A/C

 Malfunction Indicator Lamp

If the indicator comes on while driving, it means one of the engine’s emissions control systems may have a problem. Even though you may feel no difference in your vehicle’s performance, it can reduce your fuel economy and cause increased emissions. Continued operation may cause

© 2016-2025 Copyright www.hcrv.net