Honda CR-V: Engine Cooling
Honda CR-V (2006–2011) Service Manual / Engine Cooling
- Cooling System
- Radiator Cap Test
- Water Passage Replacement
- EGR Passage Removal and Installation
- Fan, Fan Motor, Shroud Removal and Installation
- Radiator Replacement
- Fan Controls
READ NEXT:
Cooling System
Component Location Index
COOLANT SEPARATOR
EXHAUST GAS RECIRCULATION
(EGR) PASSAGE
THERMOSTAT
RADIATOR
ENGINE COOLANT TEMPERATURE
(ECT) SENSOR 2
RADIATOR FAN ASSEMBLY
A/C COND
Radiator Cap Test
1. Remove the radiator cap (A), wet the seal with
engine coolant, then install it on the pressure tester
(B) (commercially available).
2. Apply a pressure of 93-123 kPa
(0.95-1.25 kgf/cm2, 14-18 psi)
Water Passage Replacement
1. Drain the engine coolant.
2. Remove the alternator.
3. Remove the condenser fan shroud assembly.
4. Remove the A/C compressor without disconnecting
the A/C hoses (see step 34).
5. Remove the in
SEE MORE:
DTC 41-1x ("x" can be 0 thru 9 or A thru F):
No Signal From the Left Front Impact Sensor
Specia1 Tools Required
SRS inflator simulator 07SAZ-TB4011A
SRS simulator lead L 070AZ-SNAA300
NOTE: Before doing this troubleshooting procedure,
review SRS Precautions and Procedures.
1. Erase the DTC memory.
2. Turn the ignition switch ON (II), and check that the
SRS indicator comes on for
Rear Driveshaft
Rear Driveshaft Removal
1. Raise the vehicle on a lift, and remove the rear
wheels.
2. Lift up the locking tab (A) on the spindle nut (B),
then remove the nut.
3. Drain the differential fluid.
4. Remove the rear driveshaft inboard joint from the rear differential assembly.
5. Disconnect the rear
© 2016-2025 Copyright www.hcrv.net
