Honda CR-V: Engine Block
Honda CR-V (2006–2011) Service Manual / Engine Mechanical / Engine Block
Special Tools
-
Oil Seal Driver Attachment, 96 mm
-
Driver
Component Location Index
-
BAFFLE PLATE
-
LOVER BLOCK
-
DOWEL PINS
-
CRANKSHAFT OIL SEAL, TRANSMISSION END
-
THRUST WASHERS
-
ENGINE BLOCK
-
CRANKSHAFT
-
MAIN BEARINGS
-
PISTON RINGS
-
PISTON PIN
-
PISTON
-
CONNECTING ROD
-
ENGINE BLOCK
-
CONNECTING ROD BEARINGS
-
CONNECTING ROD BEARING CAP
-
CONNECTING ROD BOLTS
- Connecting Rod and Crankshaft End Play Inspection
- Connecting Rod Bearing Replacement
- Oil Pan Removal
- Crankshaft and Piston Removal
- Block and Piston Inspection
- Piston, Pin, and Connecting Rod Replacement
- Piston Ring Replacement
- Crankshaft Installation
- Oil Pan Installation
READ NEXT:
Connecting Rod and Crankshaft End Play
Inspection
1. Remove the oil pump.
2. Remove the baffle plates (see step 7).
3. Measure the connecting rod end play with a feeler
gauge between the connecting rod and crankshaft.
Connecting Rod End Play
Standa
Connecting Rod Bearing Replacement
Rod Bearing Clearance Inspection
1. Remove the oil pump.
2. Remove the baffle plates (see step 7).
3. Remove the connecting rod cap and bearing half.
4. Clean the crankshaft rod journal and bearing
Oil Pan Removal
1. If the engine is already out of the vehicle, go to step
20.
2. Raise the vehicle on the lift to full height.
3. Drain the engine oil.
4. Remove the front wheels.
5. Remove the splash shield (se
SEE MORE:
Replacing a Parking Light/Front Side Marker Light Bulb
1. Open the hood.
To change the parking light/front
side marker on the driver’s side,
remove the fuse box fromits stay
by pulling out.
2. Remove the socket from the
headlight assembly by turning it
one-quarter turn counterclockwise.
3. Pull the bulb straight out of its
socket. P
Vehicle Stability Assist (VSA ), aka Electronic Stability Control (ESC),
System
The vehicle stability assist (VSA)
system helps to stabilize the vehicle
during cornering if the vehicle turns
more or less than desired. It also
assists you in maintaining traction
while accelerating on loose or
slippery road surfaces. It does this
by regulating the engine’s output
© 2016-2025 Copyright www.hcrv.net
