Honda CR-V manuals

Honda CR-V: Engine Cooling

Honda CR-V (2006–2011) Service Manual / Engine Cooling

READ NEXT:

 Cooling System

Component Location Index COOLANT SEPARATOR EXHAUST GAS RECIRCULATION (EGR) PASSAGE THERMOSTAT RADIATOR ENGINE COOLANT TEMPERATURE (ECT) SENSOR 2 RADIATOR FAN ASSEMBLY A/C COND

 Radiator Cap Test

1. Remove the radiator cap (A), wet the seal with engine coolant, then install it on the pressure tester (B) (commercially available). 2. Apply a pressure of 93-123 kPa (0.95-1.25 kgf/cm2, 14-18 psi)

 Water Passage Replacement

1. Drain the engine coolant. 2. Remove the alternator. 3. Remove the condenser fan shroud assembly. 4. Remove the A/C compressor without disconnecting the A/C hoses (see step 34). 5. Remove the in

SEE MORE:

 MICU Input Test

1. Before testing, troubleshoot the B-CAN System Diagnosis Test Mode A, and check the No.8 (10 A), No. 10 (7.5 A), and No. 38 (30 A) fuses in the under-dash fuse/relay box. 2. Disconnect under-dash fuse/relay box connectors E, F, S, and T. NOTE: All connector views are wire side of female termin

 DTC P1549: Charging System High Voltage

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information. If a high voltage battery (24 V, etc.) is connected to the vehicle, this DTC can be stored. 1. Turn the ignition switch ON (II). 2. Clear the DTC with the HDS.

© 2016-2025 Copyright www.hcrv.net