Honda CR-V: Engine Block
Honda CR-V (2006–2011) Service Manual / Engine Mechanical / Engine Block
Special Tools
-
Oil Seal Driver Attachment, 96 mm
-
Driver
Component Location Index
-
BAFFLE PLATE
-
LOVER BLOCK
-
DOWEL PINS
-
CRANKSHAFT OIL SEAL, TRANSMISSION END
-
THRUST WASHERS
-
ENGINE BLOCK
-
CRANKSHAFT
-
MAIN BEARINGS
-
PISTON RINGS
-
PISTON PIN
-
PISTON
-
CONNECTING ROD
-
ENGINE BLOCK
-
CONNECTING ROD BEARINGS
-
CONNECTING ROD BEARING CAP
-
CONNECTING ROD BOLTS
- Connecting Rod and Crankshaft End Play Inspection
- Connecting Rod Bearing Replacement
- Oil Pan Removal
- Crankshaft and Piston Removal
- Block and Piston Inspection
- Piston, Pin, and Connecting Rod Replacement
- Piston Ring Replacement
- Crankshaft Installation
- Oil Pan Installation
READ NEXT:
Connecting Rod and Crankshaft End Play
Inspection
1. Remove the oil pump.
2. Remove the baffle plates (see step 7).
3. Measure the connecting rod end play with a feeler
gauge between the connecting rod and crankshaft.
Connecting Rod End Play
Standa
Connecting Rod Bearing Replacement
Rod Bearing Clearance Inspection
1. Remove the oil pump.
2. Remove the baffle plates (see step 7).
3. Remove the connecting rod cap and bearing half.
4. Clean the crankshaft rod journal and bearing
Oil Pan Removal
1. If the engine is already out of the vehicle, go to step
20.
2. Raise the vehicle on the lift to full height.
3. Drain the engine oil.
4. Remove the front wheels.
5. Remove the splash shield (se
SEE MORE:
Cruise Control
Component Location Index
CRUISE MAIN INDICATOR
CRUISE CONTROL INDICATOR
CRUISE CONTROL
COMBINATION SWITCH
BRAKE PEDAL POSITION SWITCH
POWERTRAIN CONTROL MODULE (PCM)
TRANSMISSION RANGE SWITCH
Symptom Troubleshooting
Index
Circuit Diagram
Cruise Control Input Test
1. Connect
Lower Ball Joint Replacement
Special Tools Required
Ball joint remover, 32 mm 07MAC-SL0A 102
Ball joint thread protector, 14 mm 071AF-S3VA000
1. Remove the front wheel.
2. Remove the flange bolt and flange nuts from the
lower arm (A).
NOTE: During installation, install a new flange bolt
and new flange nuts. After lightly
© 2016-2025 Copyright www.hcrv.net
