Honda CR-V manuals

Honda CR-V: Engine Block

Honda CR-V (2006–2011) Service Manual / Engine Mechanical / Engine Block

Special Tools

Honda CR-V. Engine Block

Honda CR-V. Engine Block

  1. Oil Seal Driver Attachment, 96 mm

  2. Driver

Component Location Index

Honda CR-V. Engine Block

Honda CR-V. Engine Block

READ NEXT:

 Connecting Rod and Crankshaft End Play Inspection

1. Remove the oil pump. 2. Remove the baffle plates (see step 7). 3. Measure the connecting rod end play with a feeler gauge between the connecting rod and crankshaft. Connecting Rod End Play Standa

 Connecting Rod Bearing Replacement

Rod Bearing Clearance Inspection 1. Remove the oil pump. 2. Remove the baffle plates (see step 7). 3. Remove the connecting rod cap and bearing half. 4. Clean the crankshaft rod journal and bearing

 Oil Pan Removal

1. If the engine is already out of the vehicle, go to step 20. 2. Raise the vehicle on the lift to full height. 3. Drain the engine oil. 4. Remove the front wheels. 5. Remove the splash shield (se

SEE MORE:

 No sound is heard from speaker(s) (display is normal) (with navigation)

NOTE: Set the fader and balance positions to the center. Before doing symptom troubleshooting, do the power switch will not turn ON troubleshooting. 1. Check that the volume button is not set to the MIN level. Is it at MIN level? YES-Raise the volume level, and recheck the function. NO-Go to

 DTC Troubleshooting

DTC 11, 13, 15, 17: Low Tire Pressure NOTE: If low tire pressure is detected, the control unit sets one or more of these DTCs, and turns on the low pressure indicator. If the low pressure indicator comes on due to true low tire pressure, and the customer corrects it before bringing the vehicle in, t

© 2016-2026 Copyright www.hcrv.net