Honda CR-V: Engine Cooling

READ NEXT:

 Cooling System

Component Location Index COOLANT SEPARATOR EXHAUST GAS RECIRCULATION (EGR) PASSAGE THERMOSTAT RADIATOR ENGINE COOLANT TEMPERATURE (ECT) SENSOR 2 RADIATOR FAN ASSEMBLY A/C COND

 Radiator Cap Test

1. Remove the radiator cap (A), wet the seal with engine coolant, then install it on the pressure tester (B) (commercially available). 2. Apply a pressure of 93-123 kPa (0.95-1.25 kgf/cm2, 14-18 psi)

 Water Passage Replacement

1. Drain the engine coolant. 2. Remove the alternator. 3. Remove the condenser fan shroud assembly. 4. Remove the A/C compressor without disconnecting the A/C hoses (see step 34). 5. Remove the in

SEE MORE:

 Changing a Flat Tire

If you have a flat tire while driving, stop in a safe place to change it. Drive slowly along the shoulder until you get to an exit or an area to stop that is far away from the traffic lanes. The vehicle can easily roll off the jack, seriously injuring anyone underneath. Follow the d

 DTC P0128: Cooling System Malfunction

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information. 1. Turn the ignition switch ON (II). 2. Clear the DTC with the HDS. 3. Turn the blower switch OFF. 4. Check the FAN CTRL in the DATA LIST with the HDS. Is it OFF?

© 2016-2026 Copyright www.hcrv.net