Honda CR-V: Engine Block
Honda CR-V (2006–2011) Service Manual / Engine Mechanical / Engine Block
Special Tools
-
Oil Seal Driver Attachment, 96 mm
-
Driver
Component Location Index
-
BAFFLE PLATE
-
LOVER BLOCK
-
DOWEL PINS
-
CRANKSHAFT OIL SEAL, TRANSMISSION END
-
THRUST WASHERS
-
ENGINE BLOCK
-
CRANKSHAFT
-
MAIN BEARINGS
-
PISTON RINGS
-
PISTON PIN
-
PISTON
-
CONNECTING ROD
-
ENGINE BLOCK
-
CONNECTING ROD BEARINGS
-
CONNECTING ROD BEARING CAP
-
CONNECTING ROD BOLTS
- Connecting Rod and Crankshaft End Play Inspection
- Connecting Rod Bearing Replacement
- Oil Pan Removal
- Crankshaft and Piston Removal
- Block and Piston Inspection
- Piston, Pin, and Connecting Rod Replacement
- Piston Ring Replacement
- Crankshaft Installation
- Oil Pan Installation
READ NEXT:
Connecting Rod and Crankshaft End Play
Inspection
1. Remove the oil pump.
2. Remove the baffle plates (see step 7).
3. Measure the connecting rod end play with a feeler
gauge between the connecting rod and crankshaft.
Connecting Rod End Play
Standa
Connecting Rod Bearing Replacement
Rod Bearing Clearance Inspection
1. Remove the oil pump.
2. Remove the baffle plates (see step 7).
3. Remove the connecting rod cap and bearing half.
4. Clean the crankshaft rod journal and bearing
Oil Pan Removal
1. If the engine is already out of the vehicle, go to step
20.
2. Raise the vehicle on the lift to full height.
3. Drain the engine oil.
4. Remove the front wheels.
5. Remove the splash shield (se
SEE MORE:
To Change or Select Tracks/Files
You can use the SEEK button while
a disc is playing to change tracks
(files in MP3/WMA mode).
In MP3/WMA mode, use the
or
button to select
folders in the disc, and use the SEEK
button to change files.
SEEK/SKIP - Each time you
press and release the
side, the
player skips forwa
DTC P0010: VTC Oil Control Solenoid Valve
Malfunction
NOTE: Before you troubleshoot, record all freeze data and any on-board
snapshot, and review the general troubleshooting information.
1. Turn the ignition switch ON (II).
2. Clear the DTC with the HDS.
3. Start the engine. Hold the engine speed at
3,000 rpm without load (in Park or neutral) until
© 2016-2025 Copyright www.hcrv.net
