Honda CR-V manuals

Honda CR-V: Engine Block

Honda CR-V (2006–2011) Service Manual / Engine Mechanical / Engine Block

Special Tools

Honda CR-V. Engine Block

Honda CR-V. Engine Block

  1. Oil Seal Driver Attachment, 96 mm

  2. Driver

Component Location Index

Honda CR-V. Engine Block

Honda CR-V. Engine Block

READ NEXT:

 Connecting Rod and Crankshaft End Play Inspection

1. Remove the oil pump. 2. Remove the baffle plates (see step 7). 3. Measure the connecting rod end play with a feeler gauge between the connecting rod and crankshaft. Connecting Rod End Play Standa

 Connecting Rod Bearing Replacement

Rod Bearing Clearance Inspection 1. Remove the oil pump. 2. Remove the baffle plates (see step 7). 3. Remove the connecting rod cap and bearing half. 4. Clean the crankshaft rod journal and bearing

 Oil Pan Removal

1. If the engine is already out of the vehicle, go to step 20. 2. Raise the vehicle on the lift to full height. 3. Drain the engine oil. 4. Remove the front wheels. 5. Remove the splash shield (se

SEE MORE:

 Column Cover Removal/Installation

SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service. NOTE: Take care not to scratch the dashboard and related parts. 1. Release the tilt/telescopic lock lever, tilt the steering wheel to fully down, and pull

 Oil Pump Overhaul

Exploded View Oil Pump Removal 1. Turn the crankshaft pulley so its top dead center (TDC) mark (A) lines up with the pointer (B). 2. Remove the oil pan. 3. Remove and discard the oil pump chain tensioner. 4. To hold the rear balancer shaft, insert a 6 mm pin driver (A) into the maintenance hole

© 2016-2025 Copyright www.hcrv.net