Honda CR-V manuals

Honda CR-V: Engine Block

Honda CR-V (2006–2011) Service Manual / Engine Mechanical / Engine Block

Special Tools

Honda CR-V. Engine Block

Honda CR-V. Engine Block

  1. Oil Seal Driver Attachment, 96 mm

  2. Driver

Component Location Index

Honda CR-V. Engine Block

Honda CR-V. Engine Block

READ NEXT:

 Connecting Rod and Crankshaft End Play Inspection

1. Remove the oil pump. 2. Remove the baffle plates (see step 7). 3. Measure the connecting rod end play with a feeler gauge between the connecting rod and crankshaft. Connecting Rod End Play Standa

 Connecting Rod Bearing Replacement

Rod Bearing Clearance Inspection 1. Remove the oil pump. 2. Remove the baffle plates (see step 7). 3. Remove the connecting rod cap and bearing half. 4. Clean the crankshaft rod journal and bearing

 Oil Pan Removal

1. If the engine is already out of the vehicle, go to step 20. 2. Raise the vehicle on the lift to full height. 3. Drain the engine oil. 4. Remove the front wheels. 5. Remove the splash shield (se

SEE MORE:

 DTC Troubleshooting

DTC P0461: Fuel Level Sensor (Fuel Gauge Sending Unit) Range/Performance Problem NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information. Because it requires 162 miles (260 km) of driving without refueling to complete

 Exterior Lights

Component Location Index DAYTIME RUNNING LIGHTS CIRCUIT HEADLIGHTS FRONT SIDE MARKER/PARKING/ TURN SIGNAL LIGHTS HIGH MOUNT BRAKE LIGHT LICENSE PLATE LIGHT TAILLIGHT and BRAKE LIGHT REAR TURN SIGNAL LIGHT BACK-UP LIGHT LIGHTS-ON INDICATOR HIGH BEAM INDICATOR DRL INDICATOR COMB

© 2016-2025 Copyright www.hcrv.net