Honda CR-V: Technical Information

The diagrams in this section give you the dimensions and capacities of your vehicle and the locations of the identification numbers. It also includes information you should know about your vehicle’s tires and emissions control systems.

READ NEXT:

 Identification Numbers

Your vehicle has several identifying numbers located in various places. The vehicle identification number (VIN) is the 17-digit number your dealer uses to register your vehicle for warranty

 Specifications

Dimensions Weights Engine Capacities Capacities *1: Excluding the oil remaining in the engine *2: Including the coolant in the reserve tank and that remaining in the engine Reserve

 DOT Tire Quality Grading (U.S. Vehicles)

The tires on your vehicle meet all U.S. Federal Safety Requirements. All tires are also graded for treadwear, traction, and temperature performance according to Department of Transportation

SEE MORE:

 Drive Belt Inspection

1. Inspect the belt for cracks and damage. If the belt is cracked or damaged, replace it. 2. Check that the auto-tensioner indicator (A) is within the standard range (B) as shown. If it is out of the standard range, replace the drive belt. Drive Belt Removal/Installation Special Tools Required Bel

 Cylinder Head Installation

1. Install a new coolant separator in the engine block whenever the engine block is replaced. 2. Clean the cylinder head and block surface. 3. Install the new cylinder head gasket (A) and dowel pins (B) on the engine block. Always use a new cylinder head gasket. Set the crankshaft to top dead cen

© 2016-2025 Copyright www.hcrv.net