Honda CR-V: Steering
Honda CR-V (2006–2011) Service Manual / Steering
Special Tools
- Piston Seal Ring Sizing Tool
- Bushing Base
- Piston Seal Ring Guide
- Cylinder End Seal Slide
- Locknut Wrench, 40 mm
- Ball Joint Remover, 28 mm
- Valve Seal Ring Sizing Tool
- Sleeve Seal Ring Guide
- Pulley Holder
- Sleeve Seal Ring Sizing Tool, 36 mm
- P/S Joint Adapter (pump)
- P/S Joint Adapter (Hose)
- Cylinder End Seal Remover Attachment
- P/S Pressure Gauge
- Driver
- Attachment, 28 x 30 mm
Component Location Index
- POWER STEERING FLUID RESERVOIR
- Fluid Leakage Inspection
- Fluid Replacement
- Power Steering Hose, Line, and Pressure Switch Replacement
- POWER STEERING PUMP
- Drive Belt Inspection
- Pressure Test with T/N 07406-0010001
- Pressure Test with T/N 07406-001000A or 07406-001A101
- Replacement
- Overhaul
- DRIVER'S AIRBAG
- Replacement
- STEERING WHEEL
- Removal
- Disassembly/Reassembly
- Installation
- STEERING COLUMN
- Removal and Installation
- Steering Column/Tilt/Telescopic/Lock Lever Inspection
- Steering Lock Replacement
- POWER STEERING GEARBOX
- Rack Guide Adjustment
- Removal
- Overhaul
- Installation
- Tie-rod Ball Joint Boot Replacement
- Gearbox Mount Cushion Replacement
Symptom Troubleshooting Index
Find the symptom in the chart below, and do the related procedures in the order listed until you find the cause.
READ NEXT:
Symptom Troubleshooting
Hard Steering
1. Check the power assist.
Is the initial turning load more than 34 N (3.5 kgf,
7.7 Ibf) ?
YES-Go to step 2.
NO-Power assist is OK.
2. Connect the P/S joint adapter (pump), P/S joint
Pump Pressure Test
Pump Pressure Test with T/N 07406-0010001
Special Tools Required
P/S joint adapter (pump) 07ZAK-S7C0100
P/S joint adapter (hose) 07ZAK-S7C0200
P/S pressure gauge 07406-0010001
Check the fluid pre
Pump
Pump Replacement
1. Place a suitable container under the vehicle.
2. Drain the power steering fluid from the reservoir.
3. Remove the drive belt (A) from the pump pulley.
4. Cover the auto-tensione
SEE MORE:
Folding the Rear Seats Down
Each rear seat-back can be folded
down separately to give more cargo
room. With either of the outer seatbacks
folded-down, you can still
carry a passenger in the rear seat.
With the center seat-back foldeddown,
either outer seating position
can be used.
You can also fold up the left or
DTC 12, 14, 16, 18: Wheel Sensor (Electrical
Noise/Intermittent Interruption)
NOTE:
If the ABS and other indicators come on because of
electrical noise, the indicators will go off when you
test-drive the vehicle at 10 mph (15 km/h) or more
and noise is gone.
An incorrectly installed wheel bearing can cause one
of these DTCs.
1. Turn the ignition switch OFF.
2. Check
© 2016-2025 Copyright www.hcrv.net
