Honda CR-V manuals

Honda CR-V: Engine Cooling

Honda CR-V (2006–2011) Service Manual / Engine Cooling

READ NEXT:

 Cooling System

Component Location Index COOLANT SEPARATOR EXHAUST GAS RECIRCULATION (EGR) PASSAGE THERMOSTAT RADIATOR ENGINE COOLANT TEMPERATURE (ECT) SENSOR 2 RADIATOR FAN ASSEMBLY A/C COND

 Radiator Cap Test

1. Remove the radiator cap (A), wet the seal with engine coolant, then install it on the pressure tester (B) (commercially available). 2. Apply a pressure of 93-123 kPa (0.95-1.25 kgf/cm2, 14-18 psi)

 Water Passage Replacement

1. Drain the engine coolant. 2. Remove the alternator. 3. Remove the condenser fan shroud assembly. 4. Remove the A/C compressor without disconnecting the A/C hoses (see step 34). 5. Remove the in

SEE MORE:

 Crankshaft Installation

Special Tools Required Driver 077 49-00 10000 Oil seal driver attachment, 96 mm 07ZAD-PNAA.100 1. Check the connecting rod bearing clearance with plastigage. 2. Check the main bearing clearance with plastigage. 3. Install the bearing halves in the engine block and connecting rods. 4. Apply a

 Fuel Pressure Relieving

Before disconnecting fuel lines or hoses, relieve pressure from the system by disabling the fuel pump and then disconnecting the fuel tube/quick connect fitting in the engine compartment. With the HDS 1. Make sure you have the anti-theft code for the audio system. 2. Remove the fuel fill cap, to re

© 2016-2026 Copyright www.hcrv.net