Honda CR-V: DTC Troubleshooting

READ NEXT:

 DTC 11, 13, 15, 17: Wheel Sensor (Open/Short to Body Ground/Short to Power)

1. Turn the ignition switch ON (II). 2. Check for DTCs with the HDS. Is DTC 87 indicated with DTC 11,13,15, and/or 17 at the same time? YES-Go to step 9. NO-Go to step 3. 3. Clear the DTC with the

 DTC 12, 14, 16, 18: Wheel Sensor (Electrical Noise/Intermittent Interruption)

NOTE: If the ABS and other indicators come on because of electrical noise, the indicators will go off when you test-drive the vehicle at 10 mph (15 km/h) or more and noise is gone. An incorrectl

 DTC 51: Motor Locked

1. Turn the ignition switch ON (II). 2. Clear the DTC with the HDS. 3. Test-drive the vehicle. Drive the vehicle at 10 mph (15 km/h) or more, with the engine speed at 2,500 rpm or more. 4. Check fo

SEE MORE:

 Tire Inspection

Every time you check inflation, you should also examine the tires for damage, foreign objects, and wear. You should look for: Bumps or bulges in the tread or side of the tire. Replace the tire if you find either of these conditions. Cuts, splits, or cracks in the side of the tire. Repla

 Accessory Power Sockets

Your vehicle has two or three accessory power sockets depending on the model. To use an accessory power socket, the ignition switch must be in the ACCESSORY (I) or ON (II) position. Each socket is intended to supply power for 12 volt DC accessories that are rated 120 watts or l

© 2016-2025 Copyright www.hcrv.net