Honda CR-V: Accessory Power Sockets
Honda CR-V (2006–2011) Owner's Manual / Instruments and Controls / Interior Convenience Items / Accessory Power Sockets
Your vehicle has two or three accessory power sockets depending on the model.
To use an accessory power socket, the ignition switch must be in the ACCESSORY (I) or ON (II) position.
Each socket is intended to supply power for 12 volt DC accessories that are rated 120 watts or less (10 amps).
None of the sockets will power an automotive type cigarette lighter element.
Make sure to put the socket cover back in place to prevent any small foreign objects from getting into the socket.
READ NEXT:
Console Compartment
EX-L model
Push the release knob to open or
close the console compartment, slide
the lid rearward.
Coat Hook
To use a coat hook, slide it out
slightly, then pull it down.
Make sure the coat hook is folded up
when you are not using it. This hook
is not designed for large or heavy
items.
Seat Under Tray
If equipped
Your vehicle has a seat under tray
located under the front passenger
seat. Use the tray by pulling on the
front center edge of the tray.
SEE MORE:
Voice Control System
You can select the AUX mode by
using the navigation system voice
control buttons, but cannot operate
the play mode functions.
The specifications for compatible
MP3 files are:
Sampling frequency:
32/44.1/48 kHz (MPEG1)
16/22.05/24 kHz (MPEG2)
Bitrate:
32/40/48/56/64/80/96/112/128/160/19
DTC P0716: Problem in Input Shaft
(Mainshaft) Speed Sensor Circuit
DTC P0716: Problem in Input Shaft
(Mainshaft) Speed Sensor Circuit
DTC P0717: Problem in Input Shaft
(Mainshaft) Speed Sensor Circuit (No Signal
Input)
NOTE:
Before you troubleshoot, record all freeze data and any on-board
snapshot, and review General Troubleshooting Information.
This code is c
© 2016-2025 Copyright www.hcrv.net
