Honda CR-V: DTC Troubleshooting

READ NEXT:

 DTC 11, 13, 15, 17: Wheel Sensor (Open/Short to Body Ground/Short to Power)

1. Turn the ignition switch ON (II). 2. Check for DTCs with the HDS. Is DTC 87 indicated with DTC 11,13,15, and/or 17 at the same time? YES-Go to step 9. NO-Go to step 3. 3. Clear the DTC with the

 DTC 12, 14, 16, 18: Wheel Sensor (Electrical Noise/Intermittent Interruption)

NOTE: If the ABS and other indicators come on because of electrical noise, the indicators will go off when you test-drive the vehicle at 10 mph (15 km/h) or more and noise is gone. An incorrectl

 DTC 51: Motor Locked

1. Turn the ignition switch ON (II). 2. Clear the DTC with the HDS. 3. Test-drive the vehicle. Drive the vehicle at 10 mph (15 km/h) or more, with the engine speed at 2,500 rpm or more. 4. Check fo

SEE MORE:

 Block and Piston Inspection

1. Remove the crankshaft and pistons. 2. Check the piston for distortion or cracks. 3. Measure the piston diameter at a point 13 mm (0.5 in.) from the bottom of the skirt. There are two standard-size pistons (No Letter or A, and B). The letter is stamped on the top of the piston. Letters are also

 Customer Service Information

Honda dealership personnel are trained professionals. They should be able to answer all your questions. If you encounter a problem that your dealership does not solve to your satisfaction, please discuss it with the dealership’s management. The service manager or general manager can

© 2016-2025 Copyright www.hcrv.net