Honda CR-V: Navigation System
Honda CR-V (2006–2011) Service Manual / Audio, Navigation,
and Telematics / Navigation System
Component Location Index
- GPS ANTENNA
- Removal/Installation
- NAVIGATION
MICROPHONE
(Inside the map light)
- Replacement
- NAVIGATION UNIT
- Removal/Installation
- REARVIEW CAMERA
- Removal/Installation
- VOICE CONTROL SWITCH
- Test
- Replacement
- PCM
- General Troubleshooting Information
- System Description
- Symptom Troubleshooting
- System Diagnostic Mode
- CD, DVD, and PC Card Removal/Installation
- Navigation Unit Removal/Installation
READ NEXT:
General Troubleshooting Information
General Operation
Refer to the navigation system manual, for the
navigation system operating procedures.
Anti-theft Feature
The navigation system has a coded theft protection
circuit. Make sure you ha
System Description
Overview
The navigation system is a highly sophisticated, hybrid locating system.
The navigation unit uses global positioning system (GPS) satellite signals,
internal yaw and vehicle speed inputs, a
Symptom Troubleshooting
No picture is displayed
NOTE: Always check the connectors for poor
connections or loose terminals between the audio unit,
audio disc changer, navigation unit, and XM receiver.
1. Check the No. 23 (10
SEE MORE:
Boot Band Installation
Special Tools Required
Boot band tool, KD-3191 or equivalent, commercially
available
Boot band pliers, Kent-Moore J-35910 or equivalent,
commercially available
Double Loop Type
1. Fit the boot ends onto the driveshaft and the
inboard joint, then install the new double loop band
(A) onto the boot.
N
Injector Replacement
1. Relieve fuel pressure.
2. Remove the engine cover.
3. Disconnect the connectors (A) from the injectors.
4. Remove the ground cable bolt (G101) (B).
5. Disconnect the quick-connect fitting (C).
6. Remove the fuel rail mounting nuts (D) from the fuel rail (E).
7. Remove the injector clip (F)
© 2016-2025 Copyright www.hcrv.net
