Honda CR-V: Navigation System
Honda CR-V (2006–2011) Service Manual / Audio, Navigation,
and Telematics / Navigation System
Component Location Index
- GPS ANTENNA
- Removal/Installation
- NAVIGATION
MICROPHONE
(Inside the map light)
- Replacement
- NAVIGATION UNIT
- Removal/Installation
- REARVIEW CAMERA
- Removal/Installation
- VOICE CONTROL SWITCH
- Test
- Replacement
- PCM
- General Troubleshooting Information
- System Description
- Symptom Troubleshooting
- System Diagnostic Mode
- CD, DVD, and PC Card Removal/Installation
- Navigation Unit Removal/Installation
READ NEXT:
General Troubleshooting Information
General Operation
Refer to the navigation system manual, for the
navigation system operating procedures.
Anti-theft Feature
The navigation system has a coded theft protection
circuit. Make sure you ha
System Description
Overview
The navigation system is a highly sophisticated, hybrid locating system.
The navigation unit uses global positioning system (GPS) satellite signals,
internal yaw and vehicle speed inputs, a
Symptom Troubleshooting
No picture is displayed
NOTE: Always check the connectors for poor
connections or loose terminals between the audio unit,
audio disc changer, navigation unit, and XM receiver.
1. Check the No. 23 (10
SEE MORE:
Safety Labels
These labels are in the locations
shown. They warn you of potential
hazards that could cause serious
injury or death. Read these labels
carefully.
If a label comes off or becomes hard
to read (except for the U.S.
dashboard label which may be
removed by the owner), contact your
dealer
VTC Oil Control Solenoid Valve Removal/Test/Installation
1. Disconnect the VTC oil control solenoid valve 2P
connector (A).
2. Remove the bolt (B) and the VTC oil control
solenoid valve (C).
3. Check the VTC oil control solenoid valve strainer
for clogging. If the strainer is clogged, replace the
VTC oil control solenoid valve.
4. Note the amount of va
© 2016-2025 Copyright www.hcrv.net
