Honda CR-V: Symptom Troubleshooting
Honda CR-V (2006–2011) Service Manual / Audio, Navigation,
and Telematics / Audio System / Symptom Troubleshooting
- Poor AM or FM radio reception or interference (with navigation)
- Power switch will not turn ON (No information display and no sound) (with navigation)
- No sound is heard from speaker(s) (display is normal) (with navigation)
- Audio system sound is weak or distorted (display is normal)
- XM radio display is blank and no station information is displayed
READ NEXT:
Poor AM or FM radio reception or
interference (with navigation)
NOTE:
Check the radio reception in an open area.
Compare it to a known-good vehicle of the same
model, year, and trim level whenever possible.
If necessary, have the customer demonstrate the
sym
Power switch will not turn ON (No
information display and no sound)
(with navigation)
1. With the ignition switch ON (II), push the power
switch ON to see if navigation unit turns ON.
Does the navigation unit display operate properly, and does the audio sound
normal? YES-Intermittent
No sound is heard from speaker(s) (display is
normal) (with navigation)
NOTE:
Set the fader and balance positions to the center.
Before doing symptom troubleshooting, do the
power switch will not turn ON troubleshooting.
1. Check that the volume button is not set to
SEE MORE:
DTC P0453: FTP Sensor Circuit High Voltage
NOTE: Before you troubleshoot, record all freeze data and any on-board
snapshot, and review the general troubleshooting information.
1. Turn the ignition switch ON (II).
2. Clear the DTC with the HDS.
3. Turn the ignition switch OFF.
4. Remove the fuel fill cap.
5. Turn the ignition switch ON
Intermediate Shaft
Intermediate Shaft Removal
1. Drain the automatic transmission fluid. Reinstall the drain plug with a
new washer.
2. Remove the right driveshaft.
3. Remove the flange bolt (A) and two dowel bolts (B).
4. Remove the intermediate shaft (A) from the
differential. Hold the intermediate shaft horizon
© 2016-2025 Copyright www.hcrv.net
